Softwareupdate wave.com4 touch

Firmware Update

Please find the download of the necessary program file bellow.

Proceed as follows to perform the update:

Switch the device on.
Place the USB stick with the update data into the USB port of the wave.com4 touch (The USB stick must contain no other data except for the update)
In the engineer’s menu navigate to the factory settings menu point.
Start the software update by a long press on C 2
Wait until the update is complete. Do not disconnect the device from the mains under any circumstances during the software update.
After the update the wave.com4 touch goes into standby mode.

Note the configuration. The Settings are reset by the Software update.

Please find the download of the necessary program file bellow.

Proceed as follows to perform the update:

Unzip the ZIP file.
Turn on the device
Insert the USB stick with the unzipped "gupdtc4" folder into the USB port of the wave.com4 touch
The update then starts automatically.
The update has been completed when the control restarts and in the info box "FINISHED" appears.
Disconnect the system for 10 seconds from stream - while removing the USB stick

Our Team will be pleased to answer you questions! Phone: +43 (0) 7672 27720-567 or E-Mail: support(at)sentiotec.com.